D-Link 28F Switch User Manual


 
xStack
®
DES-3200-10/18/28/28F Layer 2 Ethernet Managed Switch User Manual
Figure 6 - 7. Add Access Rule window for Ethernet example
To set the Access Rule for Ethernet, adjust the following parameters and click Apply.
Parameter Description
Access ID
(1-65535)
Type in a unique identifier number for this access. This value can be set from 1 to 65535.
Auto Assign – Ticking this check box will instruct the Switch to automatically assign an Access ID
for the rule being created.
VLAN Name
Selecting this option instructs the Switch to examine the VLAN part of each packet header and
use this as the, or part of the, criterion for forwarding
VLAN ID (1-4094)
Mask ____ (0-FFF) – Specifies a VLAN ID.
VLAN ID
Allows the entry of a VLAN ID for a previously configured VLAN.
Source MAC
Address
Specifies a MAC address mask for the source MAC address.
Source MAC
Mask
Specifies a MAC address mask for the source MAC address. This mask is entered in a
hexadecimal format.
Destination MAC
Address
Specifies a MAC address for the destination MAC address.
Destination MAC
Mask
Specifies a MAC address mask for the destination MAC address.
802.1p (0-7)
Enter a value from 0 to 7 to specify that the access profile will apply only to packets with this
802.1p priority value.
Ethernet Type
(0-FFFF)
Enter a value that the access profile will apply only to packets with this hexadecimal 802.1Q
Ethernet type value in the packet header.
Action
Select Permit to specify that the packets that match the access profile are forwarded by the
Switch, according to any additional rule added (see below).
Select Deny to specify the packets that match the access profile are not forwarded by the Switch
and will be filtered.
Select Mirror to specify that packets that match the access profile are mirrored to a port defined
154