Filter
Top Products
DES-3010F/DES-3010FL/DES-3010G/DES-3016/DES-3018/DES-3026 Fast Ethernet Switch Manual
92
NOTE: If any ports within the trunk group become disconnected, packets
intended for the disconnected port will be load shared among the other
uplinked ports of the link aggregation group.
Link aggregation allows several ports to be grouped together and to act as a single link. This gives a
bandwidth that is a multiple of a single link's bandwidth.
Link aggregation is most commonly used to link a bandwidth intensive network device or devices, such as a
server, to the backbone of a network.
The Switch allows the creation of up to 3 link aggregation groups, each group consisting of 2 to 4 links
(ports). All of the ports in the group must be members of the same VLAN, and their STP status, static
multicast, traffic control, traffic segmentation and 802.1p default priority configurations must be identical.
Port locking, port mirroring and 802.1X must not be enabled on the trunk group. Further, the aggregated
links must all be of the same speed and should be configured as full-duplex.
The Master Port of the group is to be configured by the user, and all configuration options, including the
VLAN configuration that can be applied to the Master Port, are applied to the entire link aggregation group.
Load balancing is automatically applied to the ports in the aggregated group, and a link failure within the
group causes the network traffic to be directed to the remaining links in the group.
The Spanning Tree Protocol will treat a link aggregation group as a single link, on the switch level. On the
port level, the STP will use the port parameters of the Master Port in the calculation of port cost and in
determining the state of the link aggregation group. If two redundant link aggregation groups are configured
on the Switch, STP will block one entire group, in the same way STP will block a single port that has a
redundant link.