DES-3010F/DES-3010FL/DES-3010G/DES-3016/DES-3018/DES-3026 Fast Ethernet Switch Manual
17
First Time Connecting to the Switch
The Switch supports user-based security that can allow you to prevent unauthorized users from accessing the
Switch or changing its settings. This section tells how to log onto the Switch.
NOTE: The passwords used to access the Switch are case-sensitive;
therefore, "S" is not the same as "s."
When you first connect to the Switch, you will be presented with the first login screen (shown below).
NOTE: Press Ctrl+R to refresh the screen. This command can be used at
any time to force the console program in the Switch to refresh the console
screen.
DES-3026 Fast Ethernet Switch Command Line Interface
Firmware: Build 4.20.B27
Copyright(C) 2007 D-Link Corporation. All rights reserved.
UserName:
Figure 4- 2. Initial screen, first time connecting to the Switch
Press Enter in both the Username and Password fields. You will be given access to the command prompt
DES-3026:4#, as shown below:
There is no initial username or password. Leave the Username and Password fields blank.
DES-3026 Fast Ethernet Switch Command Line Interface
Firmware: Build 4.20.B27
Copyright(C) 2007 D-Link Corporation. All rights reserved.
UserName:
PassWord:
DES-3026:4#_
Figure 4- 3. Command Prompt
NOTE: The first user automatically gets Administrator level privileges. It is
recommended to create at least one Admin-level user account for the Switch.