Filter
Top Products
DES-3010F/DES-3010FL/DES-3010G/DES-3016/DES-3018/DES-3026 Fast Ethernet Switch Manual
21
DES-3026 Fast Ethernet Switch Command Line Interface
Firmware: Build 4.20.027
Copyright(C) 2008 D-Link Corporation. All rights reserved.
UserName:
PassWord:
DES-3026:4#config ipif System ipaddress 10.73.21.42/255.0.0.0
Command: congig ipif System ipaddress 10.73.21.42/8
Success
DES-3026:4#
Figure 4- 6. Assigning the Switch an IP Address
In the above example, the Switch was assigned an IP address of 10.7.3.21 with a subnet mask of 255.0.0.0.
The system message Success indicates that the command was executed successfully. The Switch can now be
configured and managed via Telnet and the CLI or via the Web-based management.
Connecting Devices to the Switch
After you assign IP addresses to the Switch, you can connect devices to the Switch.
To connect a device to an SFP transceiver port:
• Use your cabling requirements to select an appropriate SFP transceiver type.
• Insert the SFP transceiver (sold separately) into the SFP transceiver slot.
• Use the appropriate network cabling to connect a device to the connectors on the SFP transceiver.
NOTICE: When the SFP transceiver acquires a link, the associated
integrated 10/100/1000BASE-T port is disabled.