Filter
Top Products
24-port NWay Ethernet Switch User’s Guide
94 Using the Console Interface
Figure 6-65. Restart System screen
Factory Reset
Before performing a factory reset, be absolutely certain that this is what you want to do. Once the factory reset is done, all
of the Switch’s settings stored in NV-RAM (including TCP/IP parameters, SNMP parameters, the enabled/disabled
settings of ports, security settings, etc.) will be erased and restored to values present when the switch was purchased.
After performing the factory reset, make sure to redefine the IP settings for the Switch in the Configure IP Address
menu. Then perform a Restart System on the Switch. After these three procedures are performed, your factory reset is
complete.
Choose Factory Reset from the main menu. The following screen appears: