Filter
Top Products
24-port NWay Ethernet Switch User’s Guide
86 Using the Console Interface
Figure 6-57. Port Traffic Statistics screen
Select the desired setting in the Ports field: 1 to 4, 5 to 8, 9 to 12, 13 to 16, 17 to 20, 21-S1P2, or Slot 2 and the
desired increment setting in the Polling Interval field: 2 sec, 5 sec, 15 sec, 30 sec, 1 min, or Suspend. Pressing
CLEAR COUNTER resets the counters on this screen.
The statistic counters displayed are defined as follows:
♦ Speed If the link is up, the speed and duplex status will be displayed; if the link is down “-” will be displayed.
♦ % Utilization This shows the percentage of available bandwidth each port is using over the amount of time
specified by the update interval. For example, when a 10 Mbps port is relaying packets at 5 Mbps, the utilization is
50%.
♦ Bytes Recv. The number of good bytes received. This also includes local and dropped packets.
♦ Bytes Sent The number of good bytes sent from the respective port.
♦ Frames Recv. The number of good frames received. This also includes local and dropped packets.
♦ Frames Sent The number of good frames sent from the respective port.
♦ Total Bytes Recv. The number of bytes received, good and bad.
♦ Total Frames Recv. The number of frames received, good and bad.
♦ Last Seen MAC The MAC address of the last device that sent packets over this port.