Filter
Top Products
24-port NWay Ethernet Switch User’s Guide
42 Using the Console Interface
♦ Broadcast Storm Falling Action This setting will be activated when the Broadcast Storm Rising
Threshold and then the Broadcast Storm Falling Threshold (below) is met. This setting can be configured to
Do Nothing, Forwarding or Forwarding-Trap. See Broadcast Storm Falling Action in the Configure Ports
section of this manual for a more detailed explanation.
♦ Broadcast Storm Falling Threshold This setting defines the number of broadcast packets per second on this
port which will trigger the Broadcast Storm Falling Action (above). See Broadcast Storm Falling Threshold
in the Configure Ports section of this manual for a more detailed explanation.
Press APPLY to have the changes take effect.
STP Port State and Status reflect the current conditions of the port. They are read-only fields and cannot be changed.
Configure Slot2 Module
This screen allows you to change the port state of an optional Gigabit Ethernet module in slot 2. This is useful in the case
when you would like to partition a port due to excessive collision, or for observation, device repair, or security reasons.
Great caution, however, must be observed when disabling a port, since all data passing through the port will be discarded
by the Switch.
The Configure Slot2 Module screen appears as follows:
Figure 6-15. Slot2-Port Configuration screen
♦ State Enables or disables this port.
♦ Speed/Duplex If either a 1000BASE-SX or 1000BASE-LX module is used, this field will offer two choices:
1000M/Full or Auto. If a 1000BASE-T module is used, this field will offer the following choices: 1000M/Full,
100M/Full, 100M/Half, and Auto. Please note that DES-3251G/GL version A2 supports 1000M/Full only.
Version A3 supports 1000M/Full and Auto.