Filter
Top Products
10004281-02 CC1000dm User’s Manual 2-1
. . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
S
ETUP
2
his chapter describes the physical layout of the boards, the setup process, and
how to check for proper operation once the boards have been installed. This
chapter also includes troubleshooting, service, and warranty information.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ELECTROSTATIC DISCHARGE
Before you begin the setup process, please remember that electrostatic discharge (ESD)
can easily damage the components on the CC1000dm hardware. Electronic devices,
especially those with programmable parts, are susceptible to ESD, which can result in
operational failure. Unless you ground yourself properly, static charges can accumulate
in your body and cause ESD damage when you touch the board.
Caution: Use proper static protection and handle CC1000dm boards only when absolutely necessary. Always
wear a wriststrap to ground your body before touching a board. Keep your body grounded while
handling the board. Hold the board by its edges—do not touch any components or circuits. When
the board is not in an enclosure, store it in a static-shielding bag.
To ground yourself, wear a grounding wriststrap. Simply placing the board on top of a
static-shielding bag does not provide any protection—place it on a grounded dissipative
mat. Do not place the board on metal or other conductive surfaces.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
CC1000DM CIRCUIT BOARD
The CC1000dm circuit board is a cPCI carrier card assembly. It uses a 12-layer printed
circuit board with the following dimensions:
Width: Depth:
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
9.2 in. (233.35 mm) 6.3 in. (160.00 mm)
T
!
Ta b l e 2 - 1 :
Circuit Board Dimensions