Filter
Top Products
Pin Assignments
MVME3100 Single Board Computer Installation and Use (6806800M28C)
103
5.2.10 sATA Connectors (J28 and J29)
The MVME3100 has two sATA connectors. J28 is an internal type sATA connector located on the
planar and is intended to connect to a drive located on the board or somewhere inside the
chassis. J29 is an external type sATA connected located on the front panel and is intended to
connect to an external sATA drive. The pin assignment for these connectors is as follows:
5.3 Headers
This section describes the pin assignments of the Headers on the MVME3100. For Hheader
settings, refer to Configuring Hardware on page 22.
5.3.1 Boundary Scan Header (J24)
The 14-pin boundary scan header provides an interface for programming the on-board PLDs
and for boundary scan testing/debug purposes. The pin assignments for this header are as
follows:
Table 5-16 sATA Connectors (J28 and J29) Pin Assignments
Pin Signal
1GND
2SATA_TX+
3SATA_TX-
4GND
5SATA_RX-
6SATA_RX+
7GND
Table 5-17 Boundary Scan Header (J24) Pin Assignments
Pin Signal Signal Pin
1TRST_L GND 2
3 TDO GND 4