Filter
Top Products
Hardware Preparation and Installation
MVME3100 Single Board Computer Installation and Use (6806800M28C)
31
Procedure
Use the following steps to install the MVME3100 into your computer chassis.
1. Attach an ESD strap to your wrist. Attach the other end of the ESD strap to an
electrical ground (refer to Unpacking Guidelines). The ESD strap must be secured to
your wrist and to ground throughout the procedure.
2. Remove any filler panel that might fill that slot.
3. Install the top and bottom edge of the MVME3100 into the guides of the chassis.
4. Ensure that the levers of the two injector/ejectors are in the outward position.
5. Slide the MVME3100 into the chassis until resistance is felt.
6. Simultaneously move the injector/ejector levers in an inward direction.
7. Verify that the MVME3100 is properly seated and secure it to the chassis using the
two screws located adjacent to the injector/ejector levers.
8. Connect the appropriate cables to the MVME3100.
To remove the board from the chassis, press the red locking tabs (IEEE handles only) and
reverse the procedure.
1.6 Connecting to Peripherals
When the MVME3100 is installed in a chassis, you are ready to connect peripherals and apply
power to the board.