Filter
Top Products
MVME7100 Single Board Computer Installation and Use (6806800E08A)
Hardware Preparation and Installation Configuring the Board
36
2.4 Configuring the Board
To produce the desired configuration and ensure proper operation of the MVME7100, you may
need to carry out certain hardware modifications before installing the module.
The MVME7100 provides software control over most options: by setting bits in control registers
after installing the module in a system, you can modify its configuration. The MVME7100 control
registers are described in the MVME7100 Programmer’s Reference.
Prior to installing PMC modules on the MVME7100 baseboard, ensure that all switches that are
user configurable are set properly. To do this, refer to Figure 2-3 or the board itself, for the
location of specific switches and set the switches according to the following descriptions.
Figure 2-3 Switch Locations
S1 S2