Filter
Top Products
MVME7100 Single Board Computer Installation and Use (6806800E08A)
Hardware Preparation and Installation PMC
42
Installation Procedure
Read all notices and follow these steps to install a PMC on the baseboard.
1. Attach an ESD strap to your wrist. Attach the other end of the ESD strap to the
chassis as a ground. The ESD strap must be secured to your wrist and to ground
throughout the procedure.
2. Remove the PCI filler from the front panel.
3. Slide the edge connector of the PMC module into the front panel opening from
behind and place the PMC module on top of the baseboard. The four connectors on
the underside of the PMC module should then connect smoothly with the
corresponding connectors on the MVME7100.
4. Insert the four short phillips-head screws (provided with the PMC) through the holes
on the bottom side of the MVME7100 and the PMC front bezel and into rear
standoffs. Tighten the screws. Refer to Figure 2-6 on page 43.
5. Reinstall the MVME7100 assembly in its proper card slot. Be sure the module is well
seated in the backplane connectors. Do not damage or bend connector pins.
6. If the PMC module was installed in a non-hot swap chassis, replace the chassis or
system cover(s), reconnect the system to the AC or DC power source and turn the
equipment power on.
Damage of Circuits
Electrostatic discharge and incorrect installation and removal can damage circuits or
shorten their life.
Before touching the board or electronic components, make sure that you are working
in an ESD-safe environment.
Product Damage
Inserting or removing modules with power applied may result in damage to module
components.
Before installing or removing additional devices or modules, read the documentation
that came with the product.