Filter
Top Products
Connectors Controls, LEDs, and Connectors
MVME7100 Single Board Computer Installation and Use (6806800E08A)
63
3.3.3.7 MVME7216E PMC I/O Module (PIM) Connectors (J10, J14)
PMC Host I/O connector J10 routes only power and ground from VME P2. There are no Host
I/O signals on this connector. The MVME7100 routes PMC I/O from J14 of PMC Slot 1 to VME
P2 rows A and C. The MVME7216E routes these signals (pin-for-pin) from VME P2 to PMC I/O
Module connector J14. See Table 3-15 and Table 3-8 for the pin assignments.
Table 3-15 MVME721 Host I/O Connector (J10) Pin Assignments
Pin Signal Signal Pin
1 No Connect No Connect 2
3 No Connect No Connect 4
5 +5V No Connect 6
7 No Connect No Connect 8
9 No Connect +3.3V 10
11 No Connect No Connect 12
13 GND No Connect 14
15 No Connect No Connect 16
17 No Connect GND 18
19 No Connect No Connect 20
21 +5V No Connect 22
23 No Connect No Connect 24
25 No Connect +3.3V 26
27 No Connect No Connect 28
29 GND No Connect 30
31 No Connect No Connect 32
33 No Connect GND 34
35 No Connect No Connect 36
37 +5V No Connect 38
39 No Connect No Connect 40
41 No Connect +3.3V 42
43 No Connect No Connect 44
45 GND No Connect 46
47 No Connect No Connect 48
49 No Connect GND 50
51 No Connect No Connect 52
53 +5V No Connect 54
55 No Connect No Connect 56
57 No Connect +3.3V 58
59 No Connect No Connect 60