Filter
Top Products
2
MVME7100 Single Board Computer Installation and Use (6806800E08A)
29
Hardware Preparation and Installation
2.1 Overview
This chapter provides startup and safety instructions related to this product, hardware
preparation instruction that includes default switch settings. System considerations and
installation instructions for the baseboard, PMC, and transition module are also described in
this chapter.
A fully implemented MVME7100 consists of the baseboard plus:
z Two single-wide or one double-wide PCI Mezzanine Card (PMC) slot for added versatility.
z One transition module for support of the mapped I/O from the MVME7100 baseboard to the
P2 connector.
z Up to two optional XMCspan cards.
The following table lists the things you will need to do before you can use this board and tells
you where to find the information you need to perform each step. Be sure to read this entire
chapter, including all Caution and Warning notes, before you begin.
Table 2-1 Startup Overview
Task Page
Unpack the hardware. Unpacking and Inspecting the Board on page 30
Configure the hardware by setting jumpers
on the board and RTM.
Configuring the Board on page 36 and SEEPROM
Address Switch, S1 on page 76
Install the MVME7216E transition module in
the chassis.
Transition Module on page 40
Install PMC module (if required). Installing Accessories on page 40
Install XMCspan module (if required). XMCspan Installation and Use (6806800H03)
Install the MVME7100 in the chassis. Installing and Removing the Board on page 43
Attach cabling and apply power. Completing the Installation on page 45
Install PIM on transition module (if required). PMC Input/Output Module on page 79
Ensure that the firmware initializes the
MVME7100
Chapter 6, MOTLoad Firmware
Initialize the board Chapter 6, MOTLoad Firmware
Examine and/or change environmental
parameters.
MVME7100 Single Board Computer Programmer’s
Reference
Program the board as needed for your
applications.
MVME7100 Single Board Computer Programmer’s
Reference