Filter
Top Products
5.
Check to be sure the power button on the computer is off.
Then reconnect the power cable to the back of the
computer and to an electrical outlet.
Post-installation Setup for Memory Cards
After you install a memory card in your computer, you need to
configure your computer to use it. Follow these guidelines:
Use the Setup program on your Reference diskette to
automatically reset your computer’s configuration to include
the memory on your installed memory card. See Chapter 2
for instructions.
Use the setup program that comes with your memory card
to configure the computer for use with the installed memory
card. See your memory card manual for instructions.
If you installed a memory card and you want to use any of
its memory as expanded memory, use the EMM386.SYS
utility. See “Using Memory Beyond 640KB” in Chapter 4
and your MS-DOS Reference Manual for more information.
Also see “Post-installation Setup” at the end of this chapter for
more information on setting up your computer for use with an
option card.
To configure your computer for use with the RampagePlus® 286
memory card, you need to use CORFIX, an Epson utility on
your Reference diskette, and SMART, the RampagePlus 286
setup program. You must use CORFIX before you use SMART.
Follow these steps:
1.
Make sure that the computer is on and that MS-DOS is
loaded. (See “Loading MS-DOS” in Chapter 4 for
instructions.)
Installing Options
5-23