Filter
Top Products
7.
If the configuration of the hard disk you are installing does
not match one of the drive types listed in Appendix E,
highlight User defined and press Enter. You see the
following:
Number of cylinders
977
I
The same parameter is highlighted on the submenu above.
Enter the correct number of cylinders (tracks) for the disk
and press
Enter.
NoteNote
If you use the number keys on the numeric
keypad to
If you use the number keys on the numeric
keypad to
enter parameters, press the
Num Lock
key to enableenter parameters, press the
Num Lock
key to enable
Num Lock mode. The
Num Lock
light is on when theNum Lock mode. The
Num Lock
light is on when the
Num Lock
mode
is enabled.Num Lock
mode
is enabled.
The information for Number of cylinders is
automatically updated on the submenu above and you see
the next parameter,
Number of heads. Enter the
correct number of read/write heads for the hard disk and
press
Enter.
Follow this
same procedure for each remaining item in the
settings list (the number of sectors, the precompensation
cylinder, and the landing zone).
If you enter a parameter incorrectly, press
T
or
1
to
highlight the parameter and then enter it again.
The Setup program does not allow you to enter the total
storage capacity; it calculates the storage capacity for you,
based on what you enter for the number of cylinders, heads,
and sectors.
After you type the landing zone number and press
Enter,
the cursor block returns to the Drive submenu heading.
Running the Setup
Program
2-21