Filter
Top Products
2. To select Hard disk drive, press Enter. You see a
menu such as the following:
Change settings
** SAVE SETTINGS **
Drive 1:
Type 17
Number of cylinders
977
Number of heads
5
Number of sectors
17
Precomp.
cylinder
300
Landing
zone
971
Total capacity (MB)
40.5
Drive 2:
None
Number of cylinders 0
Number of heads
0
Number of sectors
0
Precomp.
cylinder
0
Landing zone
0
Total capacity (MB) .0
The submenu lists the settings you can change for each
drive: the number of cylinders (tracks), the number of read/
write heads, the number of sectors, the precompensation
cylinder, the landing zone (the cylinder on which you want
to park the heads when moving the computer), and the
total storage capacity in megabytes.
3. If you want to change the settings for Drive 1 (which is
drive C on most computers), press Enter to highlight
Drive
1:. If you want to change the settings for
Drive 2, press Enter and then
+
to highlight
Drive 2:.
4.
Press
Enter.
You see this submenu:
5.
If you want to change the drive type and the configuration
of the hard disk you are installing matches one of the drive
types listed in Appendix E, go to step 6.
2-18
Running the Setup
Program