Filter
Top Products
Leaving the Setup Menu
If you want to save the settings you entered, highlight
** EXIT AND SAVE
* * and press Enter at a Setup
summary screen. The Setup program stores the new settings and
resets the computer using the new configuration. If you have set
a password, you need to enter it at the key prompt. (See “Using
a Power-on Password” in Chapter 3 for instructions.) The
Operation Menu appears. Press 0 and Enter to exit the
Operation Menu.
If the computer displays an error message while it is starting up,
run the Setup program again and check the setting the error
message indicates. If the computer still displays an error message
after you check your Setup program settings, see Appendix B or
ask your dealer for assistance.
Note
If you did not
change
any settings
or you want to cancel
the
changes you made, highlight Exit without saving
at a Setup summary screen and press
Enter,
The Operation
Menu appears. Press 0 and
Enter to
exit from the Opera
Menu. (If you changed the time or date, the new setting
takes effect even if you exit the Setup program without
saving your changes.)
After you save the settings you entered, remove the Reference
diskette from your diskette drive and turn off your system. Then
follow the instructions in your MS-DOS Installation Guide to
install MS-DOS.
Note
Be sure to make a backup copy of your Reference diskette
after
you run the
Setup
program
and install M
S-DOS. See
Chapter 3 for instructions on how to copy diskettes,
2-28
Running the
Setup Program