Filter
Top Products
Basic Operation Chapter 2
))))))))))))))))))))))))))))))))))))))))))))
))))))))))))))))))))))))))))))))))))))))))))
410 Operators Manual10
The switch bank settings reflect the contents of the four software dip switches that configure the
operation of the printer. See section 5.3, specifically ^D21, ^D22, ^D23 and ^D24, for more
information on software dip switch settings.
PRINTER SERIAL #: 0-1083
PRINTED LABELS: 3097
TOTAL LABELS: 4937
PRINTED INCHES: 7150
TOTAL INCHES: 11885
POWER ON HOURS: 353
SWITCH BANK 1: 10001011
SWITCH BANK 2: 01010001
SWITCH BANK 3: 00000000
SWITCH BANK 4: 00000000
SERIAL PARAMETERS: 9600-N-8-1
LDS 410 REV 3.0 8/02/91
Status Label
Figure 3
2.2.4 PAPER-OUT MODE
After a paper-out condition, the front panel switch serves to load and realign the new label stock.
When a paper out condition occurs, the indicator light will turn red. Pressing the button and
holding it will cause the status light to go from red to yellow and feed paper. The status light will
then flash yellow until the button is pressed for a label request. It will then turn yellow and the
printer will print a duplicate of the last label printed and return to the blinking mode. This feature
was designed to facilitate batches with serial numbers or other variable data. This process can
be repeated as often as necessary to allow the paper to align itself. To return to the pre-paper
out condition, tap the button while the duplicate label is being printed. The status light will turn
green and normal printing may resume.