Filter
Top Products
Chapter 5 Printer Commands
))))))))))))))))))))))))))))))))))))))))))))
))))))))))))))))))))))))))))))))))))))))))))
410 Operators Manual 69
CHAPTER 8: OPTIONS
The 410 printer has many options available to enhance the performance of the printer. Contact
your sales representative for more information on these features. See Appendix B for ordering
information.
8.1 LABEL SUPPORT RACK
An attachment used for peel-and-dispense mode. It allows large labels to be peeled
without falling down against the printer and causing a false detection of a removed label.
Recommended for labels over 2" in height.
8.2 LARGE PAPER ROLL SUPPLY HOLDER
A paper supply holder that allows the use of 8" diameter paper supply rolls. (No charge
option if requested at time of order.)
8.3 CLOCK/BATTERY BACKED RAM SOCKET
This socket fits under the primary RAM chip and adds real-time clock features to the 410
printer. It also makes the RAM battery-backed (will not loose data when the power is off).
The clock only needs to be set once. See the configuration guide, section 5.3.4, for more
details.
This socket also creates non-volatile Ram that survives power-down conditions. Label
formats and logos can be saved in RAM for quick access. See configuration guide,
Appendix C, for more details. Note if Logos or large label formats are to be stored an
addition clock/battery backed socket may be required.
8.4 PCX2410 SOFTWARE
This 16bit DOS PC software program converts a PCX file into an OGO file that can be
downloaded to the 410 printer. The PCX or PCC file must meet the 248 X 248 pixel
scale- excluding white space - for the program to create the picture. Otherwise, the
graphic will begin with the first Y and X co-ordinate that contains dark pixel data, and
create a window of the graphic from that point. It creates a true graphic representation
(no dithering) of the PCX or PCC file. See Chapter 6 for more information on logos.