Filter
Top Products
Basic Operation Chapter 2
))))))))))))))))))))))))))))))))))))))))))))
))))))))))))))))))))))))))))))))))))))))))))
410 Operators Manual12
2.4 LOADING PAPER
The following two sections explain the dispensing modes. Refer to figures 1, 2 and 4 for the
printer components.
Printer Feed Mechanism
Figure 4
2.4.1 NORMAL AND TAG/TEAR MODES
Unwind about two feet of stock from the paper supply roll of paper. Set the roll behind the printer
on the table. Remove the label supply shaft. Insert the paper with the thermally sensitive side up,
under the rear threaded paper guide shaft, and into the printer until the paper stops. Turn the
paper guide adjust knob at the rear of the printer until the paper guides are slightly wider than the
label stock. Continue to apply pressure on the paper with your left hand. With your right hand
apply slight pressure to the printhead lift lever with your little finger. Press and hold the front
panel button with your pointing finger until the paper has advanced to a point past the printhead
and release the pressure of your little finger from the lift lever. To align the paper, press down on
the head lift lever and move the paper until the desired alignment is reached. Replace the label
supply roll shaft and stock onto the wire rack.