Filter
Top Products
Printer Commands Chapter 5
))))))))))))))))))))))))))))))))))))))))))))
))))))))))))))))))))))))))))))))))))))))))))
410 Operators Manual40
^A ^D COMMAND
23 Change SW3: Software dip switch #3. Below is the ^AB sequence:
12345678
^ABxxxxxxxx
*******.
Not Used
******.Q
Not Used
*****.)Q
1=Enable 460 Emulation, 0=Disable
****.))Q
1=Enable 450 Emulation, 0=Disable
***.)))Q
1=Enable Label Centering, 0=Disable
**.))))Q
1=Send Response After a Print
**
0=No Response After a Print
*.)))))Q
Not Used
.))))))Q
Not Used
Position:
1 Always 0
2 Always 0
3 Response After Print: If enabled, an enquiry response will be sent back through
the serial port after every print.
4 Label Centering: The printer will center all label formats if this position is set to
1. Label centering creates an X offset for the older formats that were left justified.
It will not center normal format fields on the label. It offsets a previously left
justified label. Not recommended for new applications.
5 450 Emulation: Only used if 450 format files are being sent to the printer.
6 460 Emulation: Used if 460 format files are being sent to the printer.
7 Always 0
8 Always 0