Filter
Top Products
Chapter 5 Printer Commands
))))))))))))))))))))))))))))))))))))))))))))
))))))))))))))))))))))))))))))))))))))))))))
410 Operators Manual 39
^A ^D COMMAND
22 Change SW2: Software dip switch #2. Below is the ^AB sequence:
12345678
^ABxxxxxxxx
*******.)))),
******.)))),*
*****.)))),**
*****
RRR
Power-up Label Format
*****
000=ALWAYS EPROM Format 1
*****
001=ROM or Saved Format File 1
*****
010=ROM or Saved Format File 2
*****
011=ROM or Saved Format File 3
*****
100=ROM or Saved Format File 4
*****
101=ROM or Saved Format File 5
*****
110=ROM or Saved Format File 6
*****
111=ROM or Saved Format File 7
****.))))Q
1=Use Saved Format File, 0=Rom Format
***.)))))Q
1=Print Button Enable, 0=Disable
**.))))))Q
1=Disable Button Use, 0=Enable
*.)))))))Q
1=>RESTARTED< Response Enable,
0=Disable
.))))))))Q
1=Clear Text Enable, 0=Disable
Position:
1 Clear Text Function: If enabled, all variable text strings will be erased when a
^D2<CR> is processed.
2 >RESTARTED< Response: If the printer has been reset and this switch has
been enabled, the printer will respond with to the first poll by sending the
>RESTARTED< message. If additional enquiries are made the printer will
respond normally. The >RESTARTED< message is only sent once after reset.
3 Button Use: Set to 1, the printer will not allow button use, even for paper feed.
4 Print Button: If this is 0, the button can be used for paper feed, but cannot be
used to initiate label printing.
5 Power-up Format Type: Defines the power-up label format. This parameter
determines whether to use a saved format file for the power-up label, or a ROM
format (defined by positions 6, 7, and 8). The saved format file must be battery
backed to use the saved format file feature. See Appendix C for configuration
instructions and section 5.3.7 for saved format file information. Please consult
your service organization if changes or additions to the fixed ROM formats are
required.
6,7,8 Power-up Label Format: These switches decide which format to use at power-
up.