Filter
Top Products
Chapter 2 Basic Operation
))))))))))))))))))))))))))))))))))))))))))))
))))))))))))))))))))))))))))))))))))))))))))
410 Operators Manual 11
2.3 THE STATUS LIGHT
The status light has different functions depending upon the mode of the printer. Table 1 shows
the relationship between the status light and the different modes.
Status Light
Light
Color
Mode Meaning
Green All On-Line and ready to print
Red All Printer error:
Caused by a paper-out condition or a hardware failure. If
paper is out, follow instructions in section 2.3, otherwise
turn printer off and back on. If condition persists, contact
your service representative.
Flashing
Red
All Spike or low voltage on the AC line. The unit will remain in
this mode until the condition is removed and the printer is
powered off.
Yellow Tag/tear, Peel Label present. Label is ready to be removed from the printer
mouth
Flashing
Yellow
All Printer is paused or in standby mode and is waiting for the
front panel button to be pressed. If the paper was just
changed and the reprinted label look good, press the button
during the next print cycle to clear the repeat function and
flashing yellow light.
Flashing
Yellow and
Red
All A serial port buffer overflow has occurred. Check the host
flow control for problems. (Note: the serial buffer will only
accept 9 characters after the printer drops the clear to send
signal or optionally sends the XOFF character.)
Table 1