Filter
Top Products
Printer Operation
2-4
S Top Row Keys
The Quick Macro Selection mode is entered when one of the top row keys
, , or is pressed. From the left to the right macro 1 to macro
4 will be selected. Pressing of key causes the printer to change in the
STOP-mode and in the display appears the message MACRO 2. Pressing
key [Y] confirms the macro selection and changes the printer into the READY
or BUSY mode. After this sample the printer the message on the display is
READY 2 IPP. That means macro 2 with IBM ProPrinter emulation is
selected.
If you press one of the above described key erroneously, press for
correction.
Note: Macro selection means a change of all configuration parameters of the
macro concerned.
S Lower Row Keys
In case a certain application requires a specific vertical positioning of the
printout on a continuous form, two possibilities are provided for the READY or
BUSY mode:
S vertical position adjustment VERT.POS.ADJ. with key (90)
S fanfold displacement FANFOLD DIS with key (91).
S Vertical Position Adjustment (VERT.POS.ADJ.) (90)
This can be set differently for each macro to exactly position the printout in
relation to the top edge of the form in use. Using this function, the TOP
MARGIN and BOTTOM MARGIN settings are taken into account as well.
The parameter is part of the printer´s configuration set up memory and can
be stored with the SAVE function.
The VERT. POS.ADJ. mode can directly be called up in the status READY
or BUSY by pressing key . In this case a set up is possible for the
actually paper source of the selected macro. With TRACT. L. V or
TRACT. U. V the printer asks for the value of the lower or upper tractor.