Filter
Top Products
Configuring the printer
3-20
+/- 1 = +/- / " = +/- 0,42 mm
1
60
+/- 2 = +/- / " = +/- 0,85 mm
2
60
+/- 3 = +/- / " = +/- 1,27 mm
3
60
+/- 4 = +/- / " = +/- 1,69 mm
4
60
+/- 5 = +/- / " = +/- 2,12 mm
5
60
+/- 6 = +/- / " = +/- 2,54 mm
6
60
+/- 7 = +/- / " = +/- 2,96 mm
7
60
+/- 8 = +/- / " = +/- 3,39 mm
8
60
+/- 9 = +/- / " = +/- 3,81 mm
9
60
+/- 10 = +/- / " = +/- 4,23 mm
10
60
+/- 11 = +/- / " = +/- 4,66 mm
11
60
+/- 12 = +/- / " = +/- 5,08 mm
12
60
+/- 13 = +/- / " = +/- 5,50 mm
13
60
+/- 14 = +/- / " = +/- 5,93 mm
14
60
+/- 15 = +/- / " = +/- 6,35 mm
15
60
+ 16 = + / " = + 6,77 mm
16
60
S CUT. V-POS LO. / CUT. V-POS UP. (Vertical Positioning for Cutting Device
for the CI - 4080 or for the tear off edge on the CI - 4070)
This can be set differently for each paper source (lower and upper tractor) and
is meant to be a corrective parameter to meet variations in paper size and
pre-printed material.
The parameter covers a range of - / " to + / " of an inch, where "-" is up
15 16
60 60
the page and "+" is further down the page. The default value is zero.
Note: If, for some reason, it is not desired to cut exactly on the perforation it is
very important to cut below the perforation of the printed page. If the
paper is cut above the perforation the remaining paper can easily bend and
cause a paper jam. Do not cut through a label as the blad would get dirty
by the glue.
The following table shows the possible values in inch and millimetres.