Filter
Top Products
Submenu Function
Operation
Direct Power On: Set to On to turn on the projector
simply by plugging it in.
When the power cord is plugged in, note that the projector
turns on automatically in cases such as a power outage
being restored.
Sleep Mode: When set to On, this automatically stops
projection when no image signal is being input and no
operations are carried out.
Sleep Mode Timer: When Sleep Mode is set to On, you
can set the time before the projector automatically turns off
within a range of 1 to 30 minutes.
Shutter Timer: When set to On, this automatically turns off
the projector when no operations are carried out for
approximately 120 minutes while the shutter function is
activated.
High Altitude Mode: Set to On when using the projector
above an altitude of 1,500 m.
Startup Source Search: Set whether or not (On/Off) to
automatically detect the image signal being input when the
projector is turned on.
Auto Power On: (Only available when Standby Mode is set
to Communication On.) If it is set to Computer or BNC,
the projector is turned on when the signals are received
from the Computer input port or BNC input port, even
when the projector is in standby status.
Submenu Function
Operation
Advanced: The following items can be set.
• BNC Sync Termination: Set the termination for the
signal from the BNC input port. This should usually be
set to Off. Set to On when analog (75Ω) termination such
as for switchers is necessary.
• Remote Control Type: You can select Normal or Simple
depending on the type of remote control.
Set this item to Normal to use the remote control
provided with this projector. When Simple is selected, you
can use the remote control provided with other Epson
projectors to operate this projector. This is useful if you
want to use a remote control that you are already familiar
with to operate the projector.
However, you cannot use the remote control provided
with this projector if this is set to Simple. Make sure that
the setting is correct because, if the projector is installed
on the ceiling or somewhere hard to reach, changing it
back to Normal may be difficult. Additionally, you cannot
use functions that are not equipped with this projector or
the remote control that you are using.
• Shutter Button: Select an operation to perform when
the [Shutter] button is pressed. When Shutter is selected,
the electric shutter opens/closes. When Blank is selected,
this turns off the image temporarily.
• Shutter Release: If it is set to Shutter, it is only released
by pressing the [Shutter] button, (or by sending a
command to release the shutter function).
When set to Any Button, the shutter function is released
when any operation is performed on the projector.
s "Hiding the Image Temporarily (Shutter)" p.94
• Beep: When set to Off, the confirmation buzzer does not
beep to notify you that the power turns on or off, or
cooling down is finished.
• Indicators: When set to Off, the projector's indicators are
turned off, except for error or warning.
List of Functions
124