Filter
Top Products
Indicator Cause Remedy or Status Status Monitor Dis‐
play
Power Status Lamp1/
Lamp2
Temp Filter
Blue -
Flashing
Status
varies
Status
varies
Status
varies
Orange -
On
No Air Filter The message "Install the air filter." is displayed on the projected screen.
Check that the air filter is securely attached.
s "Replacing the Air Filter" p.179
The projector automatically turns off about one minute after it detects that
there is no air filter.
If the error continues even though an air filter is attached, the air filter sensor
may be defective. Stop using the projector, remove the power cord from the
electrical outlet, and contact your local dealer or the nearest address provided in
the Epson Projector Contact List.
s Epson Projector Contact List
-
Low Air Flow This is not an error. However, projection stops automatically if the airflow falls
any further.
The message "The air filter is clogged. Clean or replace the air filter." is displayed
on the projected screen. Check the following points.
• Check that the air filter and air exhaust vents are clear, and that the projector
is not positioned against a wall.
• If the air filter is clogged, turn off the power, remove the power cord from the
electrical outlet, and then clean or replace them.
s "Cleaning the Air Filter" p.172
s "Replacing the Air Filter" p.179
If the error continues after checking the points above, stop using the projector,
remove the power cord from the electrical outlet, and contact your local dealer
or the nearest address provided in the Epson Projector Contact List.
s Epson Projector Contact List
Airflow Decline
Reading the Indicators
148