Filter
Top Products
Indicator Cause Remedy or Status Status Monitor Dis‐
play
Power Status Lamp1/
Lamp2
Temp Filter
Blue -
Flashing
Status
varies
Orange -
Flashing
Status
varies
Status
varies
Lamp Warning
Supply System
Warning (Ballast)
Check the following points.
• Remove either Lamp 1 or Lamp 2 that is indicated by the flashing indicator,
and check if it is cracked.
s "Replacing the Lamp" p.175
• Clean the air filter.
s "Cleaning the Air Filter" p.172
Lamp1 Warning (S)
Lamp1 Warning (P)
Lamp2 Warning (S)
Lamp2 Warning (P)
Power1 Warning
Power2 Warning
If the lamps are not cracked: Install the lamps again and turn on the power.
If the error continues: Replace the lamps with new ones and then turn on the
power.
If the error continues: Stop using the projector, remove the power cord from
the electrical outlet, and contact your local dealer or the nearest address
provided in the Epson Projector Contact List.
s Epson Projector Contact List
If the lamp is cracked: Contact your local dealer or the addresses on the Epson
Projector Contact List for further advice. (If one of the lamps cracks, only the
other lamp is used. Replace the cracked lamp as soon as possible.)
s Epson Projector Contact List
When using at an altitude of 1,500 m or more, set High Altitude Mode to
On.
s Extended - Operation - High Altitude Mode p.122
Set Direction to Pointing Down, Pointing Up, Angled Up, or Angled Down
when the projector is installed in a direction which is not horizontal.
s Extended - Direction p.122
Reading the Indicators
147