Filter
Top Products
Printing
Problem
Printed characters are
not what you
expected.
Solution
The typestyle or
The software may not be correctly installed
characters that are set
for your printer. Use the program’s setup
by the software cannot
(or install) procedure to check the printer
be printed.
settings, and reset as needed.
The Roman, Suns
Serif, or Draft font is
selected in your
software, but the
characters are printed
in a different font.
The wrong font is selected. If your
program accepts control codes, set the
codes to the values below to select the
built-in fonts:
Roman:
ESC k 0
Sans Serif:
ESC k 1
Draft:
ESC x 0
See Chapter 3.
Italic characters are
printed instead of the
selected graphic “line”
characters.
7-8
Troubleshooting
The wrong character table is selected. If
your application program is capable of
sending control codes, specify the Epson
Extended Graphics character table using
ESC t 1.
You can also select the graphics character
table by changing a DIP switch setting. To
do this, turn off the power, set DIP switch
1-7 to on, then turn on the printer. See
Chapter 3.