Filter
Top Products
Printing
Problem
Solution
The print position is
not what you expected
(continued).
Page length does not
match the length of the
paper.
Regular gaps occur in
the printout.
Skip over perforation
The loading position of the paper may be
is set, but the
too high or too low. Use the micro-
perforation does not
adjustment feature to reset the loading
fall in the center of the
position so that the perforation is centered
skip.
within the skip area.
Check the page length set by your
application software and adjust it if
necessary, or change the page length setting
with DIP switch 2-1.
If you are using the cut sheet feeder, the self
test function prints the number of printable
lines that can fit on a single sheet. Use this
feature to determine the correct page length
setting. See Chapter 3.
One-inch skip over perforation may be set.
Set DIP switch 2-3 to off, or use your
application program to cancel skip over
perforation. See Chapter 3.
Your application program may be setting
the top
and
bottom margins. If this is the
case, turn off skip over perforation by
setting DIP switch 2-3 to off.
The page length for continuous paper may
be set incorrectly. Set DIP switch 2-1 to 11
or 12 inches. See Chapter 3.
7-12 Troubleshooting