Filter
Top Products
Printed characters are not what you expect
The typestyles or characters you sent with your software did
not print.
Check that the software is correctly configured for your printer.
For instructions, see “Setting Up Your Printer Driver” in
Chapter 1.
The font selected on the control panel does not print.
Your software may be overriding your control panel setting.
Select the font in your software program.
The print position is not what you expect
Printing starts too high or too low on the page, or the bottom part
of one page is printed at the top of the next page.
You can adjust the loading position using the LF/FF button in
the micro-adjust mode. See “Using Micro Adjust” in Chapter 3.
Page length does not match the length of the paper.
Check the page length set by your software and adjust it if
necessary.
If you are using continuous paper, change the page length
using the Default Setting mode. See “Changing the default
settings” in Chapter 3.
Regular gaps occur in the printout.
Skip-over-perforation may be on. Set skip-over-perforation to
off in the default setting mode. See “Changing the default
settings” in Chapter 3.
L
Sunflower-P
Rev.c
A5 size Chapter 6
01/09/96 pass 1
6-6
Troubleshooting