Filter
Top Products
One page of your document has printed on two pages.
Check that the page-length setting and lines-per-page setting
in your software are correct. Also see “Changing the default
settings” in Chapter 3.
The desired paper type does not load when switching between the
cut-sheet feeder and a push tractor.
The paper release lever may not be in the proper position. Pull
the lever forward to load continuous paper or push the lever
back to load single sheets.
Continuous paper does not feed properly when using
the tractors in a push/pull position
Paper feed is crooked or jams.
The pull tractor and push tractor sprockets may not be aligned
correctly.
The paper may have too much slack, Adjust the position of the
sprockets to remove any slack along the width of the paper.
Remove any slack lengthwise by rotating the knob of the pull
tractor.
R
Sunflower-P
Rev.c
A5 size Chapter 6
01/09/96 pass 1
Troubleshooting
6-11