Filter
Top Products
3. When you resume printing, the printer automatically feeds the
paper back to the loading position and begins printing. If the
perforation does not meet the tear-off edge, you can adjust the
tear-off position using the Micro Adjust feature as described in
the previous section.
You can leave auto tear-off mode on even when you are using
single sheets because the mode is disabled when you move the
paper release lever to the single-sheet position.
Note:
Set auto tear-off mode to off in the Default Setting mode, or avoid
touching the
Tear Off/Bin
button when using the pull (top) tractor.
Using the Tear Off/Bin button
Except when using the pull (top) tractor, you can use the
Tear
Off/Bin
button to advance continuous paper to the tear-off
position by following the steps below:
1. Make sure printing has finished. Then press the
Tear Off/Bin
button until the two lights on the control panel start flashing.
The printer advances the paper to the tear-off edge.
2. Tear off all printed pages. If the perforation is not aligned with
the tear-off edge, adjust the tear-off position using the Micro
Adjust feature. See “Using Micro Adjust,” earlier in this
chapter.
3. When you resume printing, the printer feeds the paper back
to the loading position and begins printing. (You can also
manually feed the paper back to the loading position by
pressing the
Tear Off/Bin
button.)
R
Sunflower-P
Rev.c A5 size Chapter 3
01/09/96 pass 2
Using the Printer
3-17