9
The EverAccess Controller package includes two support frames to elevate the
controller in order to make wire connections more convenient. The installation is
described in the steps below:
Step 1. Mount the two support frames on a wall or on the interior of the EverAccess
enclosure. When mounting to a wall, use the mounting template included in
the packaging to help position the holes to mount the controller on a wall. If
using the EverAccess enclosure, use the four pre-drilled holes on the back
wall of the enclosure.
Step 1 Step 2
Step 2. Mount the controller base board.
a. Place the controller base board on the support frames. Line up the four
latches on the support frames with the holes on the controller base
board. Once lined up, slide the controller base board down to secure it
in place. At this point the two screw holes on the top two corners of
the controller base board should be aligned with the corresponding
holes on the support frame.
b. Secure the controller base board to the support frames with the two
screws (provided in the controller package).
Step 3. Install and mount additional door modules or the alarm module
a. Connect the pins on the lower right corner of the new module to the
connector on the bottom left corner of the installed module. Make sure
that the pins fit snugly into the receiving module.
b. Secure the module to the controller base board using the three screws
(provided in the module package).