EverFocus EFC--02-1-A Network Card User Manual


 
40
Delete All Cards
All cards can be deleted at once. At the following window:
Press
ENT
and system will prompt the user to confirm deletion:
Press
ENT
again to delete all cards.
Caution: this operation will permanently delete ALL cards from the controller
database.
Set Card Properties
Under the Card Setting menu, press
twice to bring up the following window:
Press
ENT
and system will prompt the user to enter serial number, as shown below:
After entering the serial number, press
ENT
to enter the submenu for setting card
properties. Each card has 6 properties that can be modified. Use
and
to
choose desired properties.
Status Setting
A card can be set as enabled or disabled at the following submenu:
Press
ENT
and system will show the status of current card as the figure below. Press
ENT
to toggle between the two statuses. Press to exit without effecting any
change.
Card Enabled
[ENT] to Toggle
Card Disabled
[ENT] to Toggle
Delete All Cards
Are You Sure ?
[ENT] to Confirm
Set Card
Properties
Card Serial #:
________
Status Setting
CLR