Filter
Top Products
48
Some events are critical which must trigger the alarm output, like the firm alarm input,
the zone alarm input and etc. But some events are not that important to trigger the
alarm output, like the denied access due to the invalid time. These settings all depend
on the users’ requirements. EFC-02 controller collects all events that might trigger the
alarm output and provides the full capacity to enable or disable the alarm output on
these events.
Sometimes user wishes to allocate a particular event to a particular alarm output, or
allocate alarm inputs in certain area to multiple alarm outputs. EFC-02 controller
delivers all the function and flexibility user need. User can define whether certain
event will trigger an alarm, and can further specify to which alarm output that event is
allocated.
All events that might trigger an alarm are listed below:
Fire alarm, zone alarm 1~8, unknown card, expired card, invalid card, invalid door,
invalid time, card anti-pass back fail, card PIN fail, SYS PIN fail, ARM PIN fail, door
forced open, door held open, reader lost, Alarm In 0 and remote alarm
All these events can be allocated to any alarm relay output on main module, door
module, and alarm module. The detailed configuration method is introduced in the
following section.
Enter Alarm Setting Menu
Under System menu, press
fours times to bring up the following window:
Press
ENT
to enter Alarm Setting menu. Use
and
to choose from different
menu options. All menu options under Alarm Setting are introduced below:
Alarm Setting Menu Structure
There are three submenus under Alarm Setting, as shown below:
Alarm Setting
A
larm Setting
A
larm Action Setting
Extended Alarm Setting
A
larm Time Setting