EverFocus EFC--02-1-A Network Card User Manual


 
55
Reader Lost
A Reader Lost event will be generated when controller detects that the card reader
has no signal. The default setting for Alarm Action Setting and Extended Alarm
Setting is: corresponding relay on door module has alarm output, Main alarm output
on main module has alarm output, and no alarm output is generated on alarm module
per reader lost event, as shown in the following two figures, respectively. Change
settings according to sections “Enter Alarm Action Setting Sub-menu” and “Enter
Extended Alarm Setting Sub-menu”.
Enter Alarm Time Setting Sub-menu
According to system setting, if alarm is triggered by certain event, alarm output will
remain active until user resets the alarm or certain period of time called alarm time
has elapsed. In Alarm Time setting user can set the alarm time, i.e., the time an alarm
output remains active.
Under Alarm menu, press
twice to bring up the following window:
Press
ENT
to enter Alarm Time Setting submenu. The current alarm time will be
displayed as shown below. Use numeric keys to enter the desired alarm time. Enter
minutes as a 3-digit number 0~999 and seconds as a 2-digit number 0~59. The
default value of alarm time is 1 minute. Press
ENT
to confirm. Press to exit
without effecting any change.
Armzone Setting
After an alarm module is installed, it defines 8 arm zones for its 8 alarm inputs.
EverAccess Flex Controller can treat alarm inputs in 8 arm zones in a very flexible
manner. These 8 arm zones can be armed or disarmed on the controller. For how to
arm/disarm the system, please refer to later section “ARM/DISARM”.
Enter Armzone Setting Menu
Under System menu, press
five times to bring up the following window:
Reader Lost
NNNNNNNN
Reader Lost
RRRRRRRR-YN
Alarm Time
Setting
Alarm Time
001M00S
ArmZone Setting
CLR