Filter
Top Products
44
Press
ENT
to enter Reader Setting menu. Use
and
to choose from
different menu options. All menu options under Reader Setting are introduced below:
Keypad Setting
Keypad Setting defines whether the reader is a keypad reader. For a keypad reader, if
the password property of the card is set as enabled, and the access right of the door is
set as card plus password, then user is asked to enter password when the card is
swiped on the keypad reader. At the following submenu:
Press
ENT
to enter keypad setting. System will show keypad setting status of all
installed readers. Y means the reader is a keypad reader, and N means the reader is a
non-keypad reader. By default, every reader is set as a non-keypad reader. Flex
controller will display the door number according to the number of installed door
modules. In the following example, 4 door modules (8 readers) have been installed on
the controller.
Press numeric keys to toggle the keypad setting of corresponding reader. Press
ENT
to confirm. Press to exit without effecting any change.
Reader to Door Allocation
EverAccess controller can be flexibly configured. Readers can be allocated to
different doors, and can be set as ENTER only or EXIT only. By default, each reader
is allocated as ENTER only to the door with the reader’s number. At the following
submenu:
Press
ENT
to enter Reader to Door Allocation setting. System will show the
allocation of the first reader to door as follows:
Press any of the 1-8 numeric keys to allocate the current reader to corresponding
doors. (This depends on the actual door modules installed on the controller) Press the
same numeric key to toggle between ENTER only and EXIT only. Press
or
to select reader. Press to exit.
Keypad Setting
12345678
NNNNNNNN
Reader to Door
Allocation
Reader-1
Door-1-IN
CLR
CLR