57
Address Setting
Each device connected to the same RS485 bus must have a unique address for the
purpose of communications and control. When multiple controllers connect to PC
via an RS485 bus, each controller must be assigned a distinct address. Procedures to
set controller address are as follows:
Under System menu, press
six times to bring up the following window:
Press
ENT
to enter Address Setting menu, as shown below:
Use numeric keys to enter desired address in the range 0000~9999. Press
ENT
to
confirm. Press to exit without effecting any change.
ARM/DISARM
After an alarm module is installed, it defines 8 arm zones for its 8 alarm inputs.
EverAccess Flex Controller can treat alarm inputs in 8 arm zones in a very flexible
manner. These 8 arm zones can be armed or disarmed on the controller as described
below.
Arm the System using the Controller Keypad
User must have the ARM PIN in order to utilize this function. Please refer to the
section “Set ARM PIN” in this chapter for instructions on how to set ARM PIN.
After system installation, the date and time information will be displayed on the LCD,
as shown below:
When
A
R
M
on the keypad is pressed, the system prompts the user to enter a
password, as shown below:
After entering the password, press
ENT
to confirm. The default password is 000000.
Once the password is verified the current system ARM status will be displayed as
shown below:
Address Setting
Address
____
06-01-06
THU 10:16
Password
______
CLR