Filter
Top Products
28 PRIMERGY BX600 S2 Basic Unit
Notes on Installing in the Rack Important Notes
© cognitas. Gesellschft für Technik-Dokumentation mbH 2007 Pfad: H:\windows\_projekte\Bxz\Betriebsanleitung\Version_Maerz-2007\Archiv\BX600S2_en\blade-us.k03
3.6 Notes on Installing in the Rack
V CAUTION!
● For safety reasons, at least two people are needed to install the
basic unit because of its weight and size.
● For lifting the basic unit, use the handles on the front and the fold-out
handles on the long sides of the chassis.
● Before lifting the basic unit into the rack, remove server blades, fan
units and power supplies from the system unit to reduce weight.
● For lifting the basic unit, use the handles on the front and the fold-out
handles on the long sides of the chassis.
● Never lift or transport the server using the handles on the rear.
● For safety reasons only one unit may be withdrawn from the rack at a
time when performing assembly or service work.
● Ensure that the anti-tilt bracket is correctly mounted when you set up
the rack.
● If more than one unit is withdrawn from the rack at any one time, the
rack is in danger of tilting forward.
● When connecting and disconnecting cables, read the relevant notes
in the “Important notes” chapter in the technical manual for the
relevant rack. The technical manual is supplied with the corre-
sponding rack.
● The power connection for the rack must be installed by an authorized
technician (electrician).
● If the server is integrated in a (rack) installation that receives power
from an industrial (public) power supply network with the IEC309
connector, the (public) power supply protection must comply with the
requirements for the non-industrial (public) power supply networks for
the type-A connector.
● The power supply for the rack should be divided amongst the three
phases of a three-phase power connection.