Filter
Top Products
USING SETUP MODE
Table 5.5 ADJUST Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
HARDWRE
Items
Options Description
<RCNTAJL>
-14/360, -9/360, -
4/360, 0/360
4/360, 9/360,
14/360,
GRAPHIC(*1)
r
Compensates for the forms feed erro
accumulated through feeding of rear
continuous forms. (Last page)
<CUT-ADJ>
-14/360, -9/360, -
4/360, 0/360
GRAPHIC(*1)
nsates the line spacing pitch on
y10 inches.
Decreases or increases in increments of
1/360 inch in total.
4/360, 9/360,
14/360,
accumulated for feeding single sheets
b
Compe
the basis of the spacing error
<FCSFADJ>
-14/360, -9/360, -
4/360, 0/360
APHIC(*1)
Compensates the line spacing pitch on
the basis of the spacing error
Decreases or increases in increments of
1/360 inch in total.
This option is available only when
paper is being loaded in the front cut
sheet feeder.
4/360, 9/360,
14/360,
GR
accumulated for feeding single sheets
by10 inches.
<RCSFADJ>
-14/360, -9/360, -
4/360, 0/360
4/360, 9/360,
14/360,
GRAPHIC(*1)
Compensates the line spacing pitch on
the basis of the spacing error
accumulated for feeding single sheets
by10 inches.
Decreases or increases in increments of
1/360 inch in total.
This option is available only when
paper is being loaded in the rear cut
sheet feeder.
5-36 User's Manual