Filter
Top Products
USING SETUP MODE
Table 5.6 CONFIG Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
Options Description
CONFIG
Items
<//S//>
E
Selection command (//S//).
ffectiveness of the Cut Sheet
DISABLE Makes the command ineffective.
ENABLE Makes the command effective.
No
d waits for manual insertion
te: The Cut Sheet Selection
command (//S//) changes the
paper source to the paper table
an
of a cut sheet.
<FCNT-PE>
D ont continuous
f
etection of end of fr
orms.
TRACTOR
P
t
P
C
aper end is detected by the sensor on
he tractor unit.
aper-end unprinted area:
ontinuous forms: About 101 mm
EDGE
R
c
P
m
egardless of paper end, printing
ontinues near to the edge of paper.
aper-end unprinted area: About 4
m for both continuous forms
<RCNT-PE>
D
f
etection of end of rear continuous
orms.
TRACTOR
Paper end is detected by the sensor on
the tractor unit.
Paper-end unprinted area:
Continuous forms: About 157 mm
EDGE
Regardless of paper end, printing
continues near to the edge of paper.
Paper-end unprinted area:
About 4 mm for both continuous
forms
5-42 User's Manual