Filter
Top Products
SECTION 2
45
SECTION 2
4 Mobile Multi-Bay Units
Critical Points
For the details on the units available for the PC, refer to page 35 for “Options”
IMPORTANT NOTE
When using a mobile multi-bay unit, pay attention to the following instruction to avoid failures:
The built-in CD-ROM drive unit, the built-in DVD-ROM drive unit, the built-in CD-R/RW drive
unit, and the built-in Superdisk drive unit are very delicate devices in which disks spin at
high speeds. When you are accessing a disk, do not carry the PC nor give it any shock or
vibration. It may cause the drive unit and/or the data to be damaged.
Do not store the units in a place where it becomes extremely hot or cold or the environmental
temperature drastically changes.
Do not expose the units in the direct sunlight and keep them away from a heater.
Do not store the units in a place where they undergo shocks and vibrations.
Do not use the units in a highly humid and/or dusty place.
Do not use the units leaving any liquid or metal objects inside. If a unit has a foreign matter
inside, contact your dealer or Fujitsu Service Center.
Wipe off stains with a dry, soft cloth or a soft cloth damped with neutral detergent diluted by
water. Avoid use of volatile chemicals such as benzine and thinner.
Do not disassemble the units.
Do not store or use the units near a magnet or a machine that generates a magnetic field.
❒ Before Replacing Mobile Multi-bay Unit
Some operation systems may allow you to replace a mobile multi-bay unit while the PC power is
on.
Critical Points
Prior to removing the built-in PC card unit, remove the PC card from the PC card slot.
Prior to removing the CCD camera, exit from the applications that use the camera.
Prior to removing the additional built-in battery unit, ensure that the built-in battery has
enough power. Otherwise connect the AC adapter in advance.
Thyme Sec2_43-49 19/10/2000, 20:2245