Filter
Top Products
109
• A parameter error has occurred (internally)
• The calling procedure is invalid (internally).
• The area is specified incorrectly (internally).
• The calculation result exceeded the value that can be expressed (internally).
• User definition is not registered (internally).
• Illegal value is received during communication with scanner. (internally).
Cause: This is a program error that occurs during command exchange
between the driver and the image scanner.
User response: Try again by rebooting the machine. If the error persists, contact the
retail store where the product was purchased or the nearest service
center.
• A general fault of the MSG_XXXXX response (internally).
Cause: This is a program error that usually occurs during internal message
transfer. This message involves the sub-messages described later.
User response: Contact the retail store where the product was purchased or the
nearest service center.
• A general fault of the DAT_XXXXX response (internally).
Cause: This is a program error that usually occurs during internal data
transfer. This message involves the sub-messages described later.
User response: Contact the retail store where the product was purchased or the
nearest maintenance service center.
• A general fault of the DAT_XXXXX, MSG_SET, and unsupported type response.
(Internally)
Cause: This is a program error that usually occurs while making the internal
data settings.
User response: Contact the place of purchase or your nearest maintenance and service
center.