Filter
Top Products
111
7.1.2 Error messages relating to gamma correction pattern editing
• Enter a positive decimal value.
Cause: A value other than a number has been entered as the gamma
correction value.
Alternatively, 0 or a negative value has been entered.
User response: Reenter a valid value.
• The file could not be created.
Cause: The file for saving could not be created. There is insufficient space to
save the file or the disk to which the file was to be saved is corrupted.
Alternatively, writing to the directory in which the file was to be
saved may not be allowed or other programs relating to disk access
may be affecting performance.
User response: Increase the amount of available space on the disk.
Use a utility such as chkdsk or scandisk to check the hard disk.
Ensure that any background programs that access the disk are not
operating
If this error message continues to be displayed, contact the place of
purchase or your nearest maintenance and service center.
• The file cannot be opened.
Cause: The file could not be opened.
The specified file name may be incorrect or the disk from which it is
being read may be corrupted. Alternatively, the specified file may be
a write-only file or other programs relating to disk access may be
affecting performance.
User response: If the specified filename is correct, use a utility such as chkdsk or
scandisk to check the hard disk. Ensure that no background programs
that access the disk are operating.
If this error message continues to be displayed, contact the place of
purchase or your nearest maintenance and service center.
• There is a file formatting error.
Cause: There is an error in the format of the specified file. Either an incorrect
file has been specified or the content of the specified file is incorrect.
User response: After checking the users' manual, check that the content of the
specified file is correct.