Fujitsu P3PC-1492-04ENC2 Scanner User Manual


 
112
7.2 Device Trouble Related to Operation
The [Scan] button is pressed, but scanning is not performed.
Cause: Has the scanner power been turned on? Has the SCSI cable been
connected correctly? Has the correct device type been selected using
[Select TWAIN Input Device]?
The scanner appears to be operating, but no image is displayed.
Cause: Has the SCSI cable between the scanner and the main unit been
connected correctly?
Is the [Brightness] value or [Threshold] value too small?
When the [Minimize] button is pressed, is the [Restore] button
displayed?
Is the application set to perform only file output?
User response: If the [Restore] button is displayed after the [Minimize] button is
pressed, the problem could be the display driver that is being used.
Contact the manufacturer of the display driver.
If a file has been selected as output destination with the environment
settings by the image scanner operation confirmation utility, try to
change to screen output.
When you don’t know how to replace consumables.
User response: Refer to section 6.6 “Device Setup Tab Folder”- [Page counter] for
replacement procedure of consumables.
Also see the Operator’s guide of the scanner for how to replace
consumables.