Filter
Top Products
www.gateway.com
21
4 Mount the enclosure in the rack as follows:
a Lift the enclosure and align it with the rack rails.
b Carefully insert the chassis slides into the rack rails and push it fully into the cabinet.
c Tighten the rear screws.
d Withdraw the enclosure until it reaches the hard stops (approximately 15.75 inches
(400 mm)).
e Return the enclosure to the fully installed position and attach to the rack using the
captive thumbscrews on the front flanges.
Module installation
The enclosure comes fully populated with all plug-in modules installed. For information on removal
or replacement of plug-in modules, see “Troubleshooting” on page 11.
Enclosure configuration
Enclosures are configured with one internal domain of 12 drives per controller module.
Enclosure cabling - single enclosure
The RAID controller module provides bi-directional connection between the host-side interface and
the drives. The drives will not be presented to the Host until they are configured and mapped by
the controller.