Filter
Top Products
CHAPTER 4: Troubleshooting
26
Drive carrier module
Removing a drive carrier module
To remove a drive carrier module:
1 Release the carrier handle by pressing the latch in the handle towards the right. The
anti-tamper lock must be off.
2 Gently withdraw the drive carrier module approximately 1 inch (25 mm) and wait 30 seconds
to let the drive spin down.
3 Withdraw the module from the drive bay.
Caution
Observe all conventional ESD precautions when handling modules and components.
Avoid contact with such things as backplane components and module connectors.
Caution
Damage can occur to a drive if it is removed while still spinning. We
recommend that you perform all steps in the following procedure to ensure that the
drive has stopped prior to removal.