Filter
Top Products
www.gateway.com
55
3 Press the control buttons (power, Vol+, play, stop, and
Mute) to test whether the current code is valid. If the
buttons work as they should, press the mode button you
pressed in step 1 once to save the code. The LED blinks
twice. You are done.
- OR -
If the buttons do not work as they should, press CH+ to
temporarily program the next most common code, then
press the control buttons again. Keep pressing the test
and CH+ buttons until you find a code that works. When
you find a working code, press the mode button you
pressed in step 1 once to save the code. The LED blinks
twice, and you are done.
Resetting the remote control
You can clear all programming and reset all remote control
settings to their factory defaults.
To reset the remote control:
1 Press and hold a mode button (CBL/SAT, DVD, LCD, or
MEDIA CENTER) for about four seconds. The LED flashes
twice.
2 Press 977. The LED flashes four times indicating that the
remote control is reset to its factory defaults.
Recording with the remote control
You can use the universal remote control to record video from
a compatible recordable video device. To prevent the
accidental recording of video, you must press the record
button twice before recording can start.
To record a program:
1 Press and hold a mode button (CBL/SAT, DVD, LCD, or
MEDIA CENTER) for the device you want to record from.
2 Press the record button. Recording begins.
Detecting low batteries
Your remote control’s batteries can last several months of
standard use, but you will need to replace them from time to
time with fresh batteries.
8512322_XHD3000 Usr Gde.book Page 55 Friday, August 10, 2007 12:33 PM